Paul Meyer
This, I'm discovering, is the key to getting something finished. I am excellent at the inspiration and planning stages of a new project, but I lack in the follow-through-till-its-done department.
I spend more time looking at ideas on Pinterest and other people's blogs than getting down to the business itself.
What I need is to plan, then act, and most important of all, not stop until it is done.
With this new self-awareness and a renewed commitment to live in a tidy organised home where I can find a pair of scissors without losing my sanity, I have completed one area of the garage revamp.
When I say 'I', that should be a 'We', I could not have done this without The Bloke.
The whole project took quite a long time, because despite my best intentions, I was side-tracked by a wardrobe revamp half-way through! You'll see the wardrobe in a later post. I am beyond excited about having that completed!
But back to the garage.
Drum roll please....
 |
| the finished area |
and a little reminder of the horrific beginning.
 |
| words fail me...truly |
How we got there...
First step was to THROW AWAY THE JUNK! This step cannot be over emphasised.
I bought the plastic 60L storage bins from The Warehouse, after seeing a design I liked on Pinterest. Once I had the bins, The Bloke and I were able to design a made-to-measure storage unit that would store all our bits and pieces in an orderly (and findable) way. I took the opportunity to add in a craft area which moves this activity away from the dining table.
Next we bought the pre-cut boards from Bunning's hardware store, the number of boards being determined by our plan. Just make sure you both count and agree on the number, as somehow we came back with one too few. Seriously annoying.
Then Miss B went to work pre-painting the boards. I highly recommend this step, even though waiting to start putting them together is really hard. For a few of the boards we skipped this step and it made painting at the end much more time consuming as each rectangle had to be painted instead of one flat plank.
 |
| Miss B pre-painting the Hardi-planks (plain pre-cut boards from Bunnings) |
The Bloke cut the shelves, and using a router, made a cut out for each shelf. He slid the shelves into place and used screws to reinforce them. He made four units like this, then attached two units together to make two complete double units. I wanted the craft area to sit between the two units for symmetry and to give the craft area a sense of containment.
 |
| the first unit put together |
I then went around with the hammer and punch to knock the nails in for plastering. If you haven't done this before, it is super simple. Line the punch up with the nail, then bang it with the hammer until the nail sits just below the surface of the wood. Fill the indentation with plaster, wait for it to dry, and sand off for a nice smooth painting surface.
 |
| facia nailed in place |
 |
| hammer and punch |
 |
| plastered and ready for sanding. |
With the first of the twin units completed and attached to the wall, I painted a top coat of creamy white paint with a small roller. This was the most tedious part, and again I was very glad to have undercoated (most of) the boards before the unit was assembled!
 |
| the finished unit |
 |
| cheap (read ugly) wooden shelf from the charity shop for $2 |
 |
| a single draw from an old set of draws too damaged for use, I levered off the front facia and handle then sanded and painted it. |
Both units were attached to the wall, and a store bought wooden counter top situated between them for my craft area. I wanted a counter top wide enough to lay out fabric etc. This countertop is the same type we used in the kitchen unit, so I was able to account for the size in the design.
The counter top is 600mm deep, and 2200mm long. I sat at a chair to check the height would be right for me to sit and sew here. I reused some cheap shelving we already had, and another old chest of draws that was surplus to requirements in the main house for additional storage.
I would like to paint the draws and units white to match, but that will have to wait.
 |
| the craft area with a place-holder top |
\
 |
| the single draw with some tin pails from the charity shop $1 each, a ceramic egg holder (free from a neighbour) for beads and a glass jar for paint brushes. |
 |
| Painted wooden shelf |
 |
| huge glass jar (charity shop again!) for wool |
 |
| A small fault in the design...where's the power socket??? |
Yes, don't forget to plan a source of power for sewing machine, hot glue gun, etc. I'll have to run a long lead over the top of the unit and down the wall instead.
 |
| the craft area |
 |
| everything in its place. |
I am so happy with how this area turned out. Most of all it gave us the confidence and skills to
tackle other areas of our home.
